Nov 3, 2021
The SEGWAY HT's sensor detects which direction itself and the rider are leaning. When it catches it, Hoverboard Cart sends a signal to control the wheel to spin in the right direction. to keep the rider standing But drivers should increase caution. It is best not to speed or race as this could cause accidents. SEGWAY HT is designed with safety in mind. It has no less than five
subsystems, each of which is designed to prevent component failure. What happened to one of those subsystems? The rest of the systems will work interchangeably, effectively, and continue until the rider goes. To reach the destination in good health, SEGWAY HT has a warning signal system when there is device damage in the subsystem.
You can see that there is a scrolling control panel located on the standing pad. There are two control panels, both of which control forward and backward motion, while the Balance sensor assembly (BSA) is used to learn how to move forward. or backward
Balance sensor assembly (BSA) Tilt sensor consists of a 5 by 5 will be waiting at the foot of pressure from users to export data to. control panel in order to send voltage to stimulate the rotation of the motor that controls the run left and right
By using a high-powered motor, but small, SEGWAY HT uses a motor with a power of 1.88 kW or more than 2.5 horsepower, with a maximum cycle of 8,000 rpm.
The figure shows that the ratio The product was used as a drive in the SEGWAY HT by engineers who designed a one-turn analogy with a piano key.